Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (CVT Transaxle - Service Information) >> Torque Converter Assembly >> Installation

Torque Converter Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the O-ring to the input shaft.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.
  2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.
    NOTE:
    • Apply CVTF to the oil seal lip.
    • Do not damage the oil seal and O-ring.
  3. Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly.
  4. Measure depth "A", from converter case end surface to drive plate contacting surface.

    Standard (reference): 

    6.8 mm (0.268in) or less

    G11255741Courtesy of SUBARU OF AMERICA, INC.
  5. Install the transmission assembly to the vehicle. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Automatic Transmission Assembly>INSTALLATION .
scientia non olet · About Mike's Workshop Manuals