Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Security System >> Inspection >> Check Security System Condition Memory

Check Security System Condition Memory

  1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.
  2. Close all the doors, trunk lid and rear gate.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter or access key.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals.

    If the 30 second monitoring lag has been set, wait for 30 seconds.

  5. Disconnect the battery ground terminal, and then reconnect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  6. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit. Ref. to SECURITY AND LOCKS>BODY INTEGRATED UNIT .
scientia non olet · About Mike's Workshop Manuals