Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2017 >> WRX STI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Lubrication System (2.0L)) >> Oil Level Switch >> Installation >> When Front CROSSMEMBER Has Been Removed

When Front CROSSMEMBER Has Been Removed

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil level switch and the clip (A) to the oil pan upper.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Locating Oil Level Switch Bolts
    G09476529Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector of oil level switch to the engine harness, and install the clip (A) securing the harness.
    Fig 2: Locating Oil Level Switch Connector And Clip
    G09476614Courtesy of SUBARU OF AMERICA, INC.
  3. Install the front crossmember. <Ref. to INSTALLATION , Front Crossmember.>
scientia non olet · About Mike's Workshop Manuals