Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2016 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Lubrication System (H6DO)) >> Oil Level Switch >> Removal

Oil Level Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the under cover. < Ref. to REMOVAL , Front Under Cover. >
  3. Drain the engine oil. < Ref. to REPLACEMENT , Engine Oil. >
  4. Disconnect the connector of the oil level switch from the engine harness, and remove the clip securing the harness to the front camshaft cap (LH) and the cylinder head (LH).
    Fig 1: Locating Oil Level Switch Connector And Clip
    G10264249Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the oil level switch from the oil pan upper.
    Fig 2: Locating Oil Level Switch Bracket Bolts
    G10264250Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals