Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2016 >> Forester 2.0XT Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Engine Control System (Diagnostics - Introduction) (H4DO)) >> General Scan Tool >> Operation >> Mode $02 (Powertrain Freeze Frame Data)

Mode $02 (Powertrain Freeze Frame Data)

WARNING: This page is about a different car, the 2017 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Refer to data denoting the operating condition when trouble is detected by on-board diagnosis system.

SUPPORT DATA AND PID LIST

PID Data Unit of measure
$02 DTC that caused freeze frame data to be stored -
$03 Fuel system control status -
$04 Calculated engine load value %
$05 Engine coolant temperature Celsius
$06 Short term fuel trim (bank 1 sensor 1) %
$07 Long term fuel trim (bank 1 sensor 1) %
$0B Intake manifold absolute pressure kPa
$0C Engine speed RPM
$0D Vehicle speed MPH
$0E Ignition timing advance °
$0F Intake air temperature Celsius
$10 Intake air amount g/s
$11 Throttle valve opening angle %
$13 Air fuel ratio sensor -
$15 Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor (bank 1 sensor 2) V and %
$1C Supporting OBD system -
$1F Elapsed time after starting the engine sec
$2C Target EGR %
$2D EGR deviation %
$2E Evaporative purge %
$2F Fuel level %
$33 Barometric pressure kPa
$42 ECM power voltage V
$43 Absolute load %
$44 A/F target lambda -
$45 Relative throttle opening angle %
$46 Ambient temperature Celsius
$47 Absolute throttle opening angle 2 %
$49 Absolute accelerator opening angle 1 %
$4A Absolute accelerator opening angle 2 %
$4C Target throttle opening angle %
$51 Applicable fuel -
$65 Neutral status -
NOTE: Refer to general scan tool manufacturer's operation manual to access freeze frame data (MODE $02).