Communication For Initializing Impossible: Wiring Diagram
WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
- Push button start system < Ref. to STARTING/CHARGING (w/o HEV) Ref. to WIRING DIAGRAM (HEV) , Push Button Start System. >
- CAN communication system < Ref. to WIRING DIAGRAM (W/O HEV) , CAN Communication System. > < Ref. to WIRING DIAGRAM (HEV) , CAN Communication System. >
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK OTHER COMMUNICATION
. Communicate with the system other than the keyless access system using the Subaru Select Monitor. |
Is the communication to other control module possible? | Go to step 2 . | Perform the "Communication for Initializing Impossible" of LAN system. < Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE (HEV) , Subaru Select Monitor. > |
| 2 CHECK DTC
. Read the DTC of the LAN system using the Subaru Select Monitor. < Ref. to OPERATION (HEV) , Read Diagnostic Trouble Code (DTC). > |
Is DTC detected? | Perform the diagnosis according to DTC. | Go to step 3 . |
3 CHECK KEYLESS ACCESS CONTROL MODULE
.
|
Is communication possible? | It is possible that temporary poor communication occurs. | Replace the keyless access control module. < Ref. to KEYLESS ACCESS CONTROL MODULE . > |
CAUTION:
For replacement procedure of keyless access control module, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".