Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2016 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Occupant Detection System (Diagnostics)) >> Occupant Detection System >> DTC B1760 Sensor Mat Abnormal >> Inspection steps

Inspection steps

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check poor contact of connectors.
    1. Turn the ignition switch to OFF.
    2. Disconnect the cable from the battery ground terminal.
    3. Check that the connector is securely connected to the occupant detection ECM.

      Criteria: The connector is securely connected.

      NOTE: If the connector is not securely connected, reconnect it, and proceed to the next check.
    4. Disconnect the connector from the occupant detection ECM.
    5. Check whether the connector terminal is damaged.

      Criteria: The terminal is not deformed or damaged.

      NG: Replace the front seat cushion ASSY RH.

      OK: Repair the connector. In the case that the fault cannot be corrected, replace the front seat cushion ASSY RH.

scientia non olet · About Mike's Workshop Manuals