Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2016 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Occupant Detection System (Diagnostics)) >> Occupant Detection System >> Checking/Clearing Diagnostic Codes

Checking/Clearing Diagnostic Codes

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reading diagnostic codes with the SSM3
    1. Connect the SSM3 to data link connector.
    2. Turn the ignition switch to ON.
    3. Select the following menu items using the SSM3: [Each System Check]/[Occupant Detection System]/[Diagnostic Code(s) Display]
      NOTE: For details on the DTCs, refer to "LIST OF DIAGNOSTIC CODES ".
  2. Clearing diagnostic codes with the SSM3
    1. Connect the SSM3 to data link connector.
    2. Turn the ignition switch to ON.
    3. Select the following menu items using the SSM3: [Each System Check]/[Occupant Detection System]/[Clear Memory]
      NOTE: After repairing the airbag system and the occupant detection system, clear the failure codes recorded in the airbag control module and the occupant detection control module.
  3. Check mode

    Refer to the trouble situation on the CHECK LIST FOR INTERVIEW to reproduce the same situation.

scientia non olet · About Mike's Workshop Manuals