System Operation Check Mode: Operation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

On «Main Menu» display, select «Each System Check».
On «System Selection Menu» display, select «Keyless access system».
On «Keyless access system» display, select «Work Support».
Select «System Operation Check Mode».
Select the check point and click [OK].

Select [Exit] to exit the drive item mode.

Data

Keyless access CM output check

Remarks

Driver seat sensor power supply

Output

Perform the output check for the driver's door touch sensor.

Stop

Passenger seat sensor power supply

Output

Perform the output check for the passenger's door touch sensor.

Stop

STSW

Output

Turn on the STSW. ⁽²⁾

Stop

ACC

Output

Turn on the ACC.

Stop

IGN1/2

Output

Turn on the IGN1/2.

Stop

Start SW character illumination lighted

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Start SW indicator lighted (green)

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Start SW indicator lighted (orange)

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Steering lock power supply

Output

Output the power supply signal from keyless access CM to steering lock CM.

Stop

⁽¹⁾	When lit by a condition other than for a system operation check mode, it will not become unlit even when set to OFF or no output.

⁽²⁾	When performed with ignition switch ON, engine will start. Therefore, great care must be exercised.

NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".