Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Starting System & Charging System (H4DO)) >> Battery Sensor >> Installation

Battery Sensor: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the battery sensor, and connect the connector (B) to the battery sensor.

    Tightening torque: 

    6 N.m (0.6 kgf-m, 4.4 ft-lb) 

  2. Attach the clip (A) to the battery holder.
    Fig 1: Locating Battery Sensor Bolt
    G10263203Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About Mike's Workshop Manuals