Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (LAN Communication System (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC U0427 Invalid Data Received From Vehicle Security Control Module >> Trouble Symptom

DTC U0427 Invalid Data Received From Vehicle Security Control Module: Trouble Symptom

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Cooperation control of keyless access does not operate properly.

DIAGNOSTICS PROCEDURE

Step Check Yes No
1 CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.  Was the basic diagnostic procedure performed up to STEP 8? Go to step 2.  Perform the basic diagnostic procedure. <Ref. to BASIC DIAGNOSTIC PROCEDURE .>
2 CHECK DTC. 
Check the displayed DTC.		 Are DTCs other than U*** displayed? Perform the diagnosis according to DTC. Go to step 3. 
3 CHECK DTC. 
Check the displayed DTC.		 Is DTC for the bus off or the data no-receive displayed? Perform the diagnosis according to DTC. Go to step 4. 
4 CHECK DTC. 
Check the displayed DTC.		 Is U0427 a current malfunction? Go to step 5.  Go to step 9. 
5 CHECK DTC. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the keyless access control module connector.
  3. Connect the disconnected connectors.
  4. Read the DTC using Subaru Select Monitor.
 Is U0427 a current malfunction? Go to step 6.  Go to step 9. 
6 CHECK DTC. 
Using the Subaru Select Monitor, read DTC of all the systems.		 Is the smart data abnormal detected in several modules? Replace the keyless access control module. <Ref. to KEYLESS ACCESS CONTROL MODULE .> Go to step 7. 
7 REPLACE MODULE. 
  1. Replace the keyless access control module.
    NOTE: Do not register the keyless access control module.
  2. Read the DTC using Subaru Select Monitor.
 Is U0427 a current malfunction? Go to step 8.  System is normal.
NOTE: Register the keyless access control module.
8 CHECK MODULE. 
  1. Reinstall the keyless access control module.
  2. Replace the body integrated unit. <Ref. to BODY INTEGRATED UNIT .>
  3. Read the DTC using Subaru Select Monitor.
 Is U0427 a current malfunction? Replace the keyless access control module. <Ref. to KEYLESS ACCESS CONTROL MODULE .> System is normal.
9 CHECK HARNESS. 
  1. Shake the harness, and check for poor contact.
  2. Read the DTC using Subaru Select Monitor.
 Is U0427 a current malfunction? Repair the poor contact of harness, or replace the harness. Go to step 10. 
10 CHECK CONNECTOR. 
Check the connector used for high speed CAN for poor contact.		 Is there poor contact of connector? Repair the connector that has poor contact, or replace harness. It is possible that temporary poor communication occurs. Delete the DTC.
scientia non olet · About Mike's Workshop Manuals