VDCCM Parameter Check

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The parameter data registered in the VDCCM is shown on the display.

Connect the Subaru Select Monitor.
On «Main Menu» display, select «Each System Check».
On «System Selection Menu» display, select «Brake Control System».
On «Brake Control System» display, select «ABS/VDC System».
When «VDC/parking brake» is displayed, select the [OK] button.
On «Brake Control Diagnosis» display, select «Work Support».
On «Work Support» display, select «Maintenance at the time of ECM replacement».
Select «Confirm on parameter».
On the «Confirm on parameter» display screen, check that the applied model and grade of the target vehicle are included, and click the [OK] button.
If the applied model and grade of the target vehicle are not included on the «Confirm on parameter» display screen, perform "parameter selection and registration". <Ref. to VDCCM PARAMETER SELECTION , MAINTENANCE MODE, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U).>