Inspection Of Switch Unit
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Operate the switches to check the continuity between terminals.
Preparation tool:
Circuit tester
Switch position Terminal No. Standard OFF A1 and A3 Less than 1 Ω INT A1 and A3 Less than 1 Ω LO A2 and A3 Less than 1 Ω HI A2 and A4 Less than 1 Ω Washer ON B2 and B3 Less than 1 Ω - Replace the switch if the inspection result is not within the standard value.
- Install the switch assembly - combination wiper select. <Ref. to INSTALLATION , Combination Switch (Wiper).>