Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Anti-Theft System - Security And Locks) >> Immobilizer Antenna >> Removal >> Model Without Keyless Access With Push Button Start

Model Without Keyless Access With Push Button Start

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. <Ref. to BATTERY , NOTE, Repair Contents.>
  2. Remove the cover assembly - column.
    1. Release the clips, and remove the cover assembly - steering UPR.
    2. Remove the screws.
    3. Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
      Fig 1: Removing Cover Assembly - Column
      G10272380Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the immobilizer antenna assembly.
    1. Disconnect the connector.
    2. Release two claws using a flat tip screwdriver or similar tool wrapped with a protection tape, and remove the immobilizer antenna assembly.
      CAUTION: Do not apply excessive force to disengage the lock of immobilizer antenna assembly. Otherwise they may be broken because those parts are the products made of a plastic.
      Fig 2: Releasing Claws Using Flat Tip Screwdriver
      G09489442Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals