Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 283 (Engine Control System (Diagnostics) (H6DO) - Introduction) >> Drive Cycle >> Procedure >> Preparation For Drive Cycle

Preparation For Drive Cycle

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. After performing the diagnostics and Clear Memory Mode, check that no DTC remains. <Ref. to CLEAR MEMORY MODE .>
NOTE: Perform the drive cycle after warming up the engine except when the engine coolant temperature at engine start is specified.
scientia non olet · About Mike's Workshop Manuals