Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Power Rear Gate (Service Information)) >> Power Rear Gate Touch Sensor >> Removal >> Touch Sensor LWR

Touch Sensor LWR

WARNING: This page is about a different car, the 2016 Subaru Outback, 2016 Subaru Legacy, 2015 Subaru Outback, and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the trim panel - rear gate. < Ref. to REMOVAL , Rear Gate Trim. >
  3. Remove the power rear gate touch sensor LWR.
    1. Remove the screws and clips.
    2. Disconnect the connector and remove the power rear gate touch sensor LWR.
      Fig 1: Locating LWR Power Rear Gate Touch Sensor Connector, Screws And Clips
      G10309986Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals