Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Power Rear Gate (Service Information)) >> Power Rear Gate Drive Unit >> Installation

Power Rear Gate Drive Unit: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback, 2016 Subaru Legacy, 2015 Subaru Outback, and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power rear gate drive unit (PRG D/U).

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

  2. Install the trim panel - rear apron LH and trim panel - rear quarter trim UPR rear LH.
  3. Install the rod - power rear gate. < Ref. to INSTALLATION , Power Rear Gate Rod. >
  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About Mike's Workshop Manuals