Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Vehicle Dynamics Control (VDC) System (Service Information)) >> VDC Sequence Control >> Operation >> VDC Sequence Control With SUBARU Select Monitor

VDC Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the event of any trouble, sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector.
    NOTE: For detailed operation procedures, refer to "Application help".
    1. Turn the ignition switch to ON.
    2. On «Start» display, select «Diagnosis».
    3. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    4. On «Main Menu» display, select «Each System».
    5. On «Select System» display, select «Brake Control System» and select «Enter».
    6. On «Select Function» display, select «Work Support».
    7. On «Work Support» display, select «VDC Function Check Mode».
  2. Operate according to the procedures displayed in the Subaru Select Monitor.
  3. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About Mike's Workshop Manuals