Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> Outback 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Ignition System (H4DO)) >> Spark Plug >> Removal >> RH Side

RH Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  2. Remove the air cleaner element and the air cleaner case (rear). <Ref. to REMOVAL , Air Cleaner Element.>
  3. Disconnect the connector from ignition coil.
    NOTE: While pressing the spring (a) shown in the figure, slide it in the direction of the arrow with a clip remover.
    Fig 1: Pressing Spark Plug Spring
    G10267376Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the ignition coil.
    Fig 2: Locating Ignition Coil Bolts
    G10263090Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the spark plug with a spark plug socket.