Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2015 >> Outback 3.6R Limited >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling Fan >> Engine Cooling System (H6DO) >> Radiator Fan Control Unit >> Installation >> Radiator Fan Control Module (Sub)

Radiator Fan Control Module (Sub)

  1. Install the radiator fan control module (sub), and install the bolts securing the radiator fan control module (sub).

    Tightening torque: 

    2.6 N.m (0.3 kgf-m, 1.9 ft-lb) 

  2. Connect the radiator fan harness connector (A) and radiator sub fan motor connector (B) to the radiator fan control module (sub).
    Fig 1: Locating Radiator Fan Control Module Bolts (Sub)
    G10264218Courtesy of SUBARU OF AMERICA, INC.
  3. Install the air intake duct. <Ref. to INSTALLATION , Air Intake Duct.>
  4. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About Mike's Workshop Manuals