Unit Inspection

Preparation tool: 

Circuit tester 

1. Check the resistance between switch terminals.
   Fig 1: Checking Resistance Between Switch Terminals

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions		Standard
   3 - 9	CANCEL SET/-- RES/+	All OFF	Approx. 4020 Ω
   3 - 9	CANCEL	ON	Less than 1 Ω
   3 - 9	SET/--	ON	Approx. 250 Ω
   3 - 9	RES/+	ON	Approx. 1470 Ω
   4 - 9	CRUISE (MAIN)	OFF	1 MΩ or more
   4 - 9		ON	Less than 1 Ω

2. Replace the cruise control command switch assembly if the inspection result is not within the standard.