Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2014 >> Outback 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (LAN System (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC U0327: Software Incompatibility With Vehicle Security Control Module >> Trouble Symptom

DTC U0327: Software Incompatibility With Vehicle Security Control Module: Trouble Symptom

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Cooperation control of keyless access does not operate properly.

CAUTION: When the keyless access Control Module is replaced, registration of the immobilizer is required. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
DTC PROCEDURE

Step Check Yes No
1 CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE  . Was the basic diagnostic procedure performed up to step 8? Go to step . Perform the basic diagnostic procedure. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
2 CHECK DTC  .
Check the displayed DTC.
Is U0327 a current malfunction? Go to step . Go to step .
3 CHECK DTC  .
Using the Subaru Select Monitor, read DTC of all the systems.
Is the smart data no-receive detected in several modules? Replace the keyless access Control Module. < Ref. to KEYLESS ACCESS Control Module . > Go to step .
4 REPLACE MODULE  .
  1. Replace the keyless access Control Module.
    CAUTION: Do not register the immobilizer.
  2. Read the DTC using Subaru Select Monitor.
Is U0327 a current malfunction? Go to step . System is normal.
5 CHECK MODULE  .
  1. Reinstall the keyless access Control Module.
  2. Replace the module that the DTC has been detected.
  3. Read the DTC using Subaru Select Monitor.
Is U0327 a current malfunction? Replace the keyless access Control Module. < Ref. to KEYLESS ACCESS Control Module . > System is normal.
6 CHECK HARNESS  .
  1. Shake the harness, and check for poor contact.
  2. Read the DTC using Subaru Select Monitor.
Is U0327 a current malfunction? Repair the poor contact of harness, or replace the harness. Go to step .
7 CHECK CONNECTOR  .
Check the connector used for high speed CAN for poor contact.
Is there poor contact of connector? Repair the connector that has poor contact, or replace harness. It is possible that temporary poor communication occurs. Delete the DTC.