Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2014 >> Outback 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Vehicle Dynamics Control (Service Information)) >> VDC Sequence Control >> Operation >> VDC Sequence Control With SUBARU Select Monitor

VDC Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: For models with EyeSight, performing the sequence control may cause the EyeSight warning light to illuminate. If the sequence control is performed, refer to "Basic Diagnostic Procedure" of "EyeSight (DIAGNOSTICS)" and check DTCs and then clear memory. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
NOTE: In the event of any trouble, sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector.
    1. Run the "PC application for Subaru Select Monitor".
    2. On «Main Menu» display, select {Each System Check}.
    3. Select {Brake Control System}. When {VDC} is displayed, select the [OK] button.
    4. Select the {Function Check Sequence} from {Work Support}.
    5. Select the {VDC Function Check Mode} from {Function Check Sequence}.
  2. Operate according to the procedures displayed in the Subaru Select Monitor.
  3. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About Mike's Workshop Manuals