Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2014 >> Outback 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Vehicle Dynamics Control (Service Information)) >> Rear ABS Wheel Speed Sensor >> Installation

Rear ABS Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be careful not to damage the sensor.
  • Do not apply excessive force to the sensor harness.
  1. Install each part in the reverse order of removal.
  2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.
    NOTE: Check the identification (mark) on the harness to make sure there is no warpage. < Ref. to SPECIFICATION , General Description. >

    Tightening torque: 

    Rear ABS wheel speed sensor: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 

    Rear wheel: 120 N.m (12.24 kgf-m, 88.5 ft-lb) 

scientia non olet · About Mike's Workshop Manuals