Pre-Delivery Inspection (PDI) Procedure: Notes

Perform the procedures indicated in the table below.

Step	Check point
1. Appearance	If the vehicle is covered with protective coating, visually check the vehicle body for damage and dents. If the protective coating has been removed, visually check the painted body surfaces in detail for damage or rust. Visually check the glass and light lenses for any damage, cracks or excessive gaps between body sheet metal. Visually check the plated parts for any damage. Check the instrument panel, console and trim for stains or dirt.
2. Tire	Check the tires for damage, defective, and dents on wheels. Check the tire air pressure.
3. Fuse installation	If the vehicle is about to be delivered to customer, attach a back-up fuse.
4. Door lock/unlock and open/close operations	Using the key, check the door can be locked or unlocked normally. Open and close all doors to check that there are no problems. Operate the power door lock switch to check that all doors and the rear gate lock and unlock normally.
5. Child safety lock	Check the child safety lock system operates normally.
6. Trunk lid open/close operations	Operate the trunk lock release lever to check that the trunk lid opens normally. Open and close the trunk lid to check that there are no problems.
7. Rear gate lock/unlock and open/close operation	Check if the rear gate can be unlocked normally through the emergency hole. Open and close the rear gate to check that there are no problems. Operate the power door lock switch to check that all doors and the rear gate lock and unlock normally.
8. Operation check of trunk lid release lever	Operate the trunk lid release lever to check that the trunk lock is unlocked normally.
9. Fuel lid opener lock release lever	Operate the fuel lid opener to check that the fuel filler lid can be unlocked normally.
10. Towing hook (eyebolt)	At factory shipment, the towing hook (eyebolt) is installed to the rear bumper. Remove the towing hook (eyebolt), store it in the holder.
11. Accessory	Check that the following accessories are equipped. Owner's manual Warranty booklet Maintenance note Spare key Key No. plate Jack Tool set Spare tire or puncture repair kit Towing hook
12. Front hood lock release	Operate the front hood lock release lever to check that the front hood opens normally.
13. Battery	Check the battery for any abnormal conditions such as rust or traces of battery fluid leaks. (Including 12 volt auxiliary battery and 12 volt engine restart battery)
14. High voltage battery air intake	Check that no dirt or fluid is adhered or mixed in.
15. Brake fluid	Check the brake fluid amount.
16. Engine oil	Check the engine oil amount.
17. Transmission gear oil	Check that the transmission gear oil level is normal.
18. CVT front differential oil	Check for leakage of CVT front differential oil.
19. Rear differential gear oil	Check for leakage of gear oil from the rear differential.
20. Engine coolant	Check the engine coolant level.
21. Clutch fluid	Check the clutch fluid amount.
22. Window washer fluid	Check the window washer fluid amount.
23. Front hood latch	Check that the front hood is closed normally and locked securely.
24. Keyless entry system	Check that the keyless entry system operates normally.
25. Keyless access	Check that the keyless access function operates normally.
26. Security system	Check that the security system operates normally.
27. Seat	Check the seat surfaces for stains or dirt. Check the seat installation conditions and functionality.
28. Seat belt	Check the seat belt installation conditions and functionality.
29. TPMS (U.S. model)	Turn the TPMS transmitter power supply to ON. If the display of TPMS warning light does not operate normally, perform the diagnosis by referring to TPMS (Diagnosis).

Step	Check point
30. Grommet installation	Install the grommet on the rear seat to the tie-down hole. (When equipped)
31. Delivery (test) mode	Turn the ignition switch to ON and check that the malfunction indicator light starts blinking.
32. Immobilizer system	Check that the engine starts with all keys that are equipped on vehicle. Check that the security indicator light operates normally.
33. Push button start	Using the access key that is equipped on vehicle, operate the push button start function to check engine start and stop operations.
34. Starting condition	Start the engine and check that the engine starts smoothly.
35. Exhaust system	Check that the exhaust noise is normal and no leaks are found.
36. Indicator and warning lights	Check that all indicator lights and warning lights are operating correctly.
37. Heater & ventilation	Check that the heater & ventilation system operates normally.
38. Air conditioner	Check that the air conditioner operates normally.
39. Multi-function display (MFD)	Check that the Multi-Function Display (MFD) function operates normally.
40. Audio	Check the radio and AUX operate normally.
41. Navigation	Check the navigation and AUX operate normally.
42. Front accessory power supply socket	Check that the front accessory power supply socket operates normally.
43. Lighting system	Check that the lighting system operates normally.
44. Illumination control	Check that the illumination control operates normally.
45. Window washer	Check that the window washer system operates normally.
46. Wiper	Check that the wiper system operates normally.
47. Wiper deicer	Check that the wiper deicer operates normally.
48. Power window	Check that the power window operates normally.
49. Sunroof	Check that the sunroof operates normally.
50. Rear defogger	Check that the rear defogger operates normally.
51. Door mirror	Check that the remote control mirror and heated mirror operate normally.
52. Diagnostic trouble code (DTC) check	Check that the diagnostic trouble code (DTC) is not detected.

Step	Check point
53. Brake test	Check the foot brake for normal operations.
54. Parking brake	Check the parking brake for normal operations.
55. Shift control	Check that the shift patterns are correct.
56. Cruise control	Check that the cruise control system operates normally.
57. Hybrid system	Check that the hybrid system operates normally.
58. EV mode lamp	Check that the EV mode lamp operates normally.

Step	Check point
59. Power steering system (electric power steering model)	Check the steering warning light operation.
60. Fluid leakage	Check for fluid/oil leaks.
61. Water leak test	Spray the vehicle with water and check for water leaks.
62. Appearance 2	Remove the protective coating (if equipped). Check the body paints for damage and stain. Check the plated parts for damage and rust.