Rear ABS Wheel Speed Sensor: Installation

CAUTION:

Be careful not to damage the sensor.
Do not apply excessive force to the sensor harness.

Install each part in the reverse order of removal.
Route the rear ABS wheel speed sensor cable to the upper arm assembly.
NOTE: Check the identification (mark) on the harness to make sure there is no warpage. < Ref. to SPECIFICATION , General Description. >

Tightening torque:

Rear ABS wheel speed sensor: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Rear wheel: 120 N.m (12.24 kgf-m, 88.5 ft-lb)