Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Continuously Variable Transaxle (CVT)) >> Oil Pump Chain >> Assembly >> Drive Sprocket

Drive Sprocket

WARNING: This page is about a different variant/trim than selected.
  1. Using the ST, install the ball bearing.
    NOTE: Use a new ball bearing.

    ST 499755502 PRESS SNAP RING

    Fig 1: Installing Ball Bearing Using Press Snap Ring
    G06654752Courtesy of SUBARU OF AMERICA, INC.
  2. Install the snap ring.
    Fig 2: Identifying Snap Ring
    G08318177Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals