Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Lubrication System (H6DO)) >> Oil Pressure Switch >> Removal

Oil Pressure Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to REMOVAL .
  4. Drain the engine oil. Refer to REPLACEMENT .
  5. Disconnect the terminal from oil pressure switch.
    Fig 1: Identifying Oil Pressure Switch Terminal
    G06651556Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the oil pressure switch.
    Fig 2: Identifying Oil Pressure Switch
    G06651557Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals