Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Starting System & Charging System (H6DO)) >> Generator >> Inspection >> Stator Coil

Stator Coil

WARNING: This page is about a different variant/trim than selected.
  1. Continuity test

    Inspect the continuity between the stator coil terminals. If continuity is not as shown in the table, replace the stator coil.

    Fig 1: Stator Coil Continuity Reference Chart
    G08582959Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Inspecting Continuity Between Stator Coil Terminals
    G06648713Courtesy of SUBARU OF AMERICA, INC.
  2. Insulation test

    Inspect the continuity between the stator coil stator core and lead wire terminals. If there is continuity, replace the stator coil because the stator coil is grounded.

    Fig 3: Performing Stator Coil Insulation Test
    G06648714Courtesy of SUBARU OF AMERICA, INC.