Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> Impreza Base, 4D Sedan, Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control System (Except WRX) >> Rear ABS Wheel Speed Sensor >> Installation

Rear ABS Wheel Speed Sensor: Installation

CAUTION: Be careful not to damage the sensor.
  1. Install each part in the reverse order of removal.
  2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.
    NOTE: Check the identification (mark) on the harness to make sure there is no warpage. < Refer to SPECIFICATION , General Description. >

    Tightening torque: 

    Rear ABS wheel speed sensor: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 

    Rear wheel: 120 N.m (12.24 kgf-m, 88.5 ft-lb) 

scientia non olet · About Mike's Workshop Manuals