Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> BRZ Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Vehicle Stability Control (VSC) System) >> Vehicle Stability Control System >> DTC C1288: Different ECM Specification >> Inspection steps

Inspection steps

WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When the skid control computer (brake actuator ASSY) has been replaced, make sure to perform [VSC(VDC) Centering Mode]. (Refer to WORK SUPPORT )
  1. Diagnostic code check (CAN communication system)
    1. Using SSM4, check whether the diagnostic code for CAN communication error has been output or not. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES )
      RESULT DESCRIPTION

      Result Go to
      No output A
      Output exists B
      1. Go to next step
      2. Go to "CAN communication system (How to troubleshoot)" (Refer to HOW TO TROUBLESHOOT )
  2. Diagnostic code list recheck
    1. Use the SSM4 to check the diagnosis codes. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES )
      RESULT DESCRIPTION

      Result Go to
      No output A
      Output exists B
      1. Go to next step
      2. Check and replacement of engine control computer (Refer to REMOVAL )

      Completed

scientia non olet · About Mike's Workshop Manuals