Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Vehicle Stability Control (VSC) System) >> Rear Speed Sensor >> Removal

Rear Speed Sensor: Removal

WARNING: This page is about a different car, the 2019 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The following procedure is for LH side. Perform the same procedures for the RH and LH side.
  1. Removal of rear tire
  2. Removal of speed sensor RR LH
    1. Remove the trunk floor mat.
    2. Disconnect the speed sensor RR LH connectors in the vehicle.
      G12591013Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the grommet and 2 harness clamps from the rear wheel housing.
      G12591014Courtesy of SUBARU OF AMERICA, INC.
    4. Remove 2 bolts from the bracket.
      G12591015Courtesy of SUBARU OF AMERICA, INC.
    5. Remove the bolts and the speed sensor RR LH.
      CAUTION: Do not let foreign matter stick to the installation part and the tip of the speed sensor RR LH.
      G12591016Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals