Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2013 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Wireless Door Lock Control System (Service Information)) >> Door Control Transmitter (Without Smart Entry) >> Registration settings

Registration settings

WARNING: This page is about a different car, the 2018 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Keyless Transmitter ID registration
    NOTE:
    • The keyless ID Additional Registration is a mode to register new keyless remote transmitters additionally while keeping the existing registered codes. It is used to add a keyless remote transmitter. If the number of registered codes exceeds 6, the first registered code is erased.
    • The Keyless ID Rewrite is a mode to register only new keyless remote transmitters after first erasing all the existing registered codes. It is used to replace the remaining keyless remote transmitter codes and keep only the one currently inserted in the ignition.
    • The readout The Number of Keyless ID Registration is a mode to confirm how many keyless remote transmitters are registered. It is used to check the number of registered codes before additional registration.
    1. Turn the ignition switch to ON with the key that includes the remote which you would like to register.
    2. Turn SSM4 on.
    3. Enter following menus: [Inspection BRZ]/[Each System Check]/[Keyless Unit Mode]/[Work Support]/[Keyless ID registration]
    4. Keyless ID registration.
      1. After selecting the [Keyless ID addition registration] or [Keyless ID renewal], press the lock and unlock switches of the keyless remote transmitter simultaneously. (For 1 second)
      2. Again, press any of the transmitter switches within 3 seconds after. (For 1 second)

        Audible tone indicates complete. (When registration is complete, the external buzzer will sound twice)

        NOTE: Up to 6 keyless IDs can be registered.
    5. End of registration mode (The mode ends if any of the following is satisfied)
      1. Completion request is issued from SSM4.
      2. SSM4 connection is shut off.
      3. No code has been entered for 30 seconds or more in registration mode.
    6. After the registration operation, perform the following.
      1. Confirm the correct operation of all keyless remote transmitters. (Does not apply to keyless access and start)
        CAUTION: If wireless operation does not work, repeat the keyless ID registration.
scientia non olet · About Mike's Workshop Manuals