How To Proceed With Troubleshooting
NOTE:
- Use the following procedures to troubleshoot the power door lock control system.
- *: Use the SSM3.
- VEHICLE BROUGHT TO WORKSHOP
NEXT
- INSPECT BATTERY VOLTAGE
Standard voltage: 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
- PROBLEM SYMPTOMS TABLE
- Refer to Problem Symptoms Table (Refer to SYMPTOM TABLE
).RESULT
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B B: Go to step 5
A: Go to Next Step
- Refer to Problem Symptoms Table (Refer to SYMPTOM TABLE
).
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Terminals of ECU (Refer to TERMINALS OF ECU ).
- Operation check (Refer to OPERATION CHECK ).
- Data List/Active Test (Refer to CURRENT DATA DISPLAY & SAVE / SYSTEM OPERATION CHECK MODE
).
NEXT
- ADJUST, REPAIR OR REPLACE
NEXT
- CONFIRMATION TEST
NEXT: END