Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Fuel Injection Fuel Systems (H6DO)) >> Throttle Body >> Inspection >> Throttle Sensor (Method With Circuit Tester)

Throttle Sensor (Method With Circuit Tester)

WARNING: This page is about a different variant/trim than selected.
  1. Remove the glove box lid assembly. Refer to GLOVE BOX .
  2. Turn the ignition switch to ON. (engine OFF)
  3. Measure the voltage between ECM connector terminals.
    Fig 1: Measuring Voltage Between ECM Connector Terminals
    G07912247Courtesy of SUBARU OF AMERICA, INC.
    Throttle sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (Full closed) 18 (+) and 1 (-) Approx. 0.6 V
    Depressed (Full opened) Approx. 4.04 V
    Sub Not depressed (Full closed) 28 (+) and 1 (-) Approx. 1.48 V
    Depressed (Full opened) Approx. 4.23 V
  4. After inspection, install the related parts in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals