Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System >> Rear Combination Light Assembly >> Removal >> Sedan Model

Sedan Model

  1. Disconnect the ground cable from battery.
  2. Remove the trunk room trim. Refer to TRUNK ROOM TRIM .
  3. Remove the rear combination light assembly.
    1. Disconnect the connector.
    2. Release the nuts and clips, then remove the rear combination light assembly.
    CAUTION: Be careful not to damage the clips.
    Fig 1: Locating Rear Combination Light Assembly Nuts And Clips
    G06653460Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals