Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Fuel Injection Fuel Systems (H4DOTC)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different car, the 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G07910732Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the generator. Refer to GENERATOR .
  4. Drain engine coolant. Refer to ENGINE COOLANT .
  5. Disconnect the connector from the engine coolant temperature sensor, and remove the engine coolant temperature sensor.
    Fig 2: Locating Engine Coolant Temperature Sensor Connector
    G06648282Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals