Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Anti-Theft System - Immobilizer (Diagnostics)) >> Subaru Select Monitor >> Operation >> How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit.
  2. Connect the diagnosis cable to Subaru Select Monitor.
  3. Connect the Subaru Select Monitor to the data link connector.
    1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
      Fig 1: Locating Data Link Connector
      G05033893Courtesy of SUBARU OF AMERICA, INC.
    2. Connect the diagnosis cable to the data link connector.
      CAUTION: Do not connect the scan tools except for Subaru Select Monitor.
  4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
  5. Using the Subaru Select Monitor, call up DTC and various data, then record them.
scientia non olet · About Mike's Workshop Manuals