Driver's Airbag Module, Curtain Airbag Module And PRETENSIONER

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

How to disconnect:
1. Using a flat tip screwdriver, pry the push lock upward to unlock.
  
  Fig 1: Prying Push Lock Upward To Unlock
  Courtesy of SUBARU OF AMERICA, INC.
2. Pull and disconnect the connector from the driver's airbag module assembly or retractor assembly.
  
  Fig 2: Disconnecting Driver's Airbag Module Assembly Or Retractor Assembly Connector
  Courtesy of SUBARU OF AMERICA, INC.
How to connect:
Connect the connector in the reverse order of disconnecting. At this time, be sure to insert the push lock until a clicking sound is heard.
CAUTION:
- Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.
- Be sure to push the push lock in securely.
  
  Fig 3: Connecting Connector To Driver Airbag Module Assembly Or Retractor Assembly
  Courtesy of SUBARU OF AMERICA, INC.
NOTE: The connector can not be connected when the push lock is in the lock position. To connect the connector, set the push lock to unlock position.