STI Model

Remove the spring pin from the slider.

Fig 1: Spring Pin And Slider
Courtesy of SUBARU OF AMERICA, INC.
Remove the slider and spring.

Fig 2: Slider And Spring
Courtesy of SUBARU OF AMERICA, INC.
Cut off the band clip.

Fig 3: Locating Band Clip
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check cable from the cable plate.

Fig 4: Reverse Check Cable And Cable Plate
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check cable from the gear shift assembly.

Fig 5: Removing Reverse Check Cable From Gear Shift Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the holder and spring.

Fig 6: Holder With Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Disassemble the lock wire.
NOTE: Do not reuse the lock wire.

Fig 7: Lock Wire
Courtesy of SUBARU OF AMERICA, INC.
Remove the boss from the rod.

Fig 8: Boss And Rod
Courtesy of SUBARU OF AMERICA, INC.
Remove the rod from lever.

Fig 9: Rod, Lever And Stay
Courtesy of SUBARU OF AMERICA, INC.
Separate the rod and inner boot.
Remove the snap ring from the stay.

Fig 10: Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Separate the gear shift lever and the stay.

Fig 11: Gear Shift Lever And Stay
Courtesy of SUBARU OF AMERICA, INC.
Remove the O-ring and bushing from the gear shift lever.

Fig 12: O-Ring And Bushing Of Gear Shift Lever
Courtesy of SUBARU OF AMERICA, INC.
Remove the spring pin, and then remove the bushing and snap ring.

Fig 13: Bushing And Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing and spacer from the boss.

Fig 14: Bushing And Spacer
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing and cushion rubber from the stay.

Fig 15: Bushing, Cushion Rubber And Stay
Courtesy of SUBARU OF AMERICA, INC.