Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2012 >> Impreza Base, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Vehicle Dynamics Control System (WRX-STI)) >> Front ABS Wheel Speed Sensor >> Inspection >> Abs Wheel Speed Sensor

Abs Wheel Speed Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Check the tip of the ABS wheel speed sensor for foreign particles or damage. If necessary, clean the tip or replace the ABS wheel speed sensor.
  2. Check the ABS wheel speed sensor cable for discontinuity. If defective, replace the ABS wheel speed sensor.
  3. Connect a 12 V power supply to No. 2 terminal of sensor connector as shown in the figure, then attach resistance to the No. 1 terminal. Rotate the wheel at about 2.75 km/h (2 MPH), and measure the voltage using an oscilloscope.

    Standard value of output voltage: 

    0.7 - 1.4 V 

    Fig 1: Connecting 12 V Power Supply To No. 2 Terminal Of Sensor Connector
    G07689968Courtesy of SUBARU OF AMERICA, INC.
  4. Replace the ABS wheel speed sensor if the inspection result is not within the standard value.
scientia non olet · About Mike's Workshop Manuals