Parameter Selection

CAUTION:

NOTE:

When the VDCCM&H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM&H/U using this function.
To confirm the applied model, refer to the "model number plate" attached on the vehicle. Ref. to IDENTIFICATION , Identification.
When the applied model is entered wrong, re-entry is possible.
When the registration has not been performed, the DTC code "Parameter selection error" is detected together with the ABS/EBD/VDC warning light illumination.

Connect the Subaru Select Monitor.
On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Brake Control System}.
Click the [OK] button after the {VDC} is displayed.
On «Brake Control Diagnosis" display, select {Selection of Parameter}.
Check the applied model and option code indicated in the "Model number plate". Ref. to IDENTIFICATION , Identification.
Enter the applied model of 7-digit alphanumeric characters and press the [Enter] key.
When the option code screen is displayed after entering the applied model, enter the option code of 4-digit alphanumeric characters and press the [Enter] key. When the option code is 3 digits, add "0" in front and enter the code as 4 digits.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after clicking the [OK] button.
Execute Clear Memory after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized.