Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2009 >> Outback R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Fuel Injection System (H4SO)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the bolt which installs crankshaft position sensor to cylinder block.
    Fig 2: Identifying Bolt Which Installs Crankshaft Position Sensor To Cylinder Block
    G04997337Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the crankshaft position sensor, and then disconnect the connector from it.
    Fig 3: Identifying Crankshaft Position Sensor Connector
    G04997386Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals