Fuel Sub Level Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while being careful of the following.

Make sure the sealing portion is free from fuel or foreign matter before installation.
Align protrusion (A) of the gasket to the position shown in the following figure.
Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
NOTE: Use a new gasket and retainer.

Tightening torque: 4.4 N.m (0.4 kgf-m, 3.2 ft-lb)

Fig 1: Identifying Upper Plate Of Fuel Sub Level Sensor Nuts Tighten Sequence
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Fuel Sub Level Sensor Bolts
Courtesy of SUBARU OF AMERICA, INC.