DTC C0045 Incorrect VDC Control Module Specifications: Trouble Symptom

ABS does not operate.
VDC does not operate.

NOTE: When parameter selection for VDCCM is improper, this DTC may be memorized.

VDCCM & H/U DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK VDCCM REPLACEMENT HISTORY.	Is there replacement history of VDCCM alone?	Go to step 2.	Go to step 3.
2 CHECK VDCCM IDENTIFICATION NUMBER. Check the identification number on the sticker attached on the VDCCM side. AT: T3 (2.5 L turbo models and OUTBACK 3.0 L models) T7 (Sedan 3.0L with 18 inch tire model) TA (2.5L non-turbo model and sedan 3.0L with 17 inch tire model) MT: T4 (2.5L turbo model) TB (2.5L non-turbo model)	Is the identification number correct?	Go to step 4.	Replace the VDCCM only.
3 CHECK VDCCM & H/U IDENTIFICATION NUMBER. Check the identification number stamped on the upper side of the H/U. AT: T3 (2.5 L turbo models and OUTBACK 3.0 L models) T7 (Sedan 3.0L with 18 inch tire model) TA (2.5L non-turbo model and sedan 3.0L with 17 inch tire model) MT: T4 (2.5L turbo model) TB (2.5L non-turbo model)	Is the identification number correct?	Go to step 4.	Replace the VDCCM & H/U.
4 CHECK PARAMETER SELECTED FOR VDCCM. Refer to PARAMETER CHECK , OPERATION, Subaru Select Monitor.	Does the parameter registered to the VDCCM match with the target vehicle?	Go to step 5.	Select and register the correct parameter. Refer to PARAMETER SELECTION , OPERATION, Subaru Select Monitor.
5 CHECK TCM SPECIFICATION. Check the TCM specification.	Is the specification of TCM same as vehicle specification?	Go to step 6.	Replace the TCM. Refer to TRANSMISSION CONTROL MODULE (TCM) . Refer to TRANSMISSION CONTROL MODULE (TCM) .
6 CHECK AT SYSTEM. Start the engine. Check the DTC in AT system.	Is DTC of AT system displayed?	Repair the AT system.	Go to step 7.
7 CHECK ECM SPECIFICATION. Check the ECM specification.	Is the specification of ECM same as vehicle specification?	Go to step 8.	Replace the ECM. Refer to ENGINE CONTROL MODULE (ECM) . Refer to ENGINE CONTROL MODULE (ECM) . Refer to ENGINE CONTROL MODULE (ECM) .
8 CHECK VDCCM & H/U. Connect all connectors. Clear the memory. Refer to CLEAR MEMORY MODE . Perform the Inspection Mode. Refer to INSPECTION MODE . Read the DTC.	Is the same DTC displayed?	Replace the VDCCM only.	Go to step 9.
9 CHECK OTHER DTC DETECTION.	Is any other DTC displayed?	Perform the diagnosis according to DTC. Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .	It results from a temporary noise interference.