Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2009 >> Legacy R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (5AT) (Diagnostics) >> Subaru Select Monitor >> Operation >> Clear Memory Mode

Clear Memory Mode

  1. Shift the select lever to "P" range.
  2. On the «Main Menu» display, select the {Each System Check}.
  3. On the «System Selection Menu» display, select the {Transmission Control System}.
  4. After transmission type information pops up, select [OK].
  5. On the «Transmission Diagnosis» display, select the {Clearing Memory}.
  6. When "Done. Turn ignition switch OFF" pops up, select [OK].
  7. Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
    • To clear the previous DTC, use {Clearing Memory}, and to clear the learned value, use {Clear Memories 2}.
    • For detailed operation procedure, refer to the "SUBARU SELECT MONITOR "
scientia non olet · About Mike's Workshop Manuals