Read Current Data
- On the «Main Menu» display, select {Each System Check}.
- On the «System Selection Menu», select {Brake Control System}.
- Click the [OK] button after the {VDC} is displayed.
- On the «Brake Control Diagnosis» screen, select {Current Data Display & Save}.
- On the «Data Display Menu», select the data display method.
- Using the scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.
SUPPORT DATA REFERENCE CHART
| Display | Contents to be monitored | Unit of measure |
|---|---|---|
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed. | km/h or MPH |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed. | km/h or MPH |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed. | km/h or MPH |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed. | km/h or MPH |
| Steer Angle Sensor Op | Steering angle detected by steering angle sensor is displayed. | deg |
| Yaw Rate Sensor Output | Vehicle angular speed detected by yaw rate sensor is displayed. | deg/s |
| Pressure Sensor Output | Brake fluid pressure detected by pressure sensor is displayed. | bar |
| Abnormal Lateral G Sensor output | Vehicle lateral acceleration detected by lateral G sensor is displayed. | m/s (m/s2 ) |
| ABS_CM Power Voltage | Voltage supplied to VDCCM & H/U is displayed. | V |
| E/G Control Stop Flag | Engine control command signal is displayed. | 1 or 0 |
| ABS Control Flag | ABS operation condition is displayed. | ON or OFF |
| EBD Control Flag | EBD operation condition is displayed. | ON or OFF |
| TCS Control Flag | TCS operation condition is displayed. | ON or OFF |
| VDC Control Flag | VDC operation condition is displayed. | ON or OFF |
| OFF Lamp | ON/OFF condition of VDC OFF indicator light is displayed. | ON or OFF |
| EBD Warning Light | ON operation of the EBD warning light is displayed. | ON or OFF |
| ABS Warning Light | ON operation of the ABS warning light is displayed. | ON or OFF |
| VDC Warning Light | ON operation of the VDC warning light is displayed. | ON or OFF |
| Valve Relay Signal | Valve relay operation signal is displayed. | ON or OFF |
| Motor Relay Signal | Motor relay operation signal is displayed. | ON or OFF |
| M. Relay monitor Voltage | Voltage applied to the motor relay is displayed. | V |
| OFF SW Signal | Operation condition of VDC OFF switch is displayed. | ON or OFF |
| Brake Switch | Brake ON/OFF is displayed. | ON or OFF |
| Fr Rr G sensor Output | Vehicle forward/reverse acceleration detected by the longitudinal G sensor is displayed. (MT vehicles only. AT vehicles are fixed at -0.1 m/s2 ). |
m/s2 |
| Clutch Switch | Clutch ON/OFF is displayed. (MT vehicles only. AT vehicles fixed at OFF). | ON or OFF |
| Reverse Signal | Reverse gear ON/OFF is displayed. (MT vehicles only. AT vehicles fixed at OFF). | ON or OFF |
NOTE:
For details concerning the operation procedure, refer to the PC application help for Subaru Select Monitor.