Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Washer System & Wiper System) >> Combination Switch (Wiper) >> Removal

Combination Switch (Wiper): Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the driver's airbag module. < Ref. to REMOVAL , Driver's Airbag Module. >
  3. Remove the steering wheel. < Ref. to REMOVAL , Steering Wheel. >
  4. Remove the screws and remove the steering column covers (upper & lower).
    Fig 1: Locating Steering Column Covers Screw
    G05022834
  5. Disconnect the connector from the combination switch.
  6. Remove the three screws, and pull out the combination base switch assembly.
    Fig 2: Locating Combination Base Switch Assembly Screws
    G05022522
  7. Remove the screws which secure the switch, then remove the combination switch.
scientia non olet · About Mike's Workshop Manuals