Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Wheel And Tire System) >> Tire Pressure Monitoring System >> Installation >> Transmitter (Tire Pressure Sensor)

Transmitter (Tire Pressure Sensor)

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmitter to the wheel by aligning it with valve hole, and then tighten with nuts.
    Fig 1: Identifying Transmitter
    G05020178

    Tightening torque: 7.5 N.m (0.76 kgf-m, 5.53 ft-lb) 

  2. Install the tires to wheels.
    CAUTION:
    • Use a tire changer when installing tire to wheel.
    • To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.
      Fig 2: Identifying Tires
      G05020179
  3. Install the wheels to vehicle. < Ref. to INSTALLATION , Steel Wheel. >
  4. Register the transmitter ID to the tire pressure monitoring control module. < Ref. to REGISTER TRANSMITTER ID , OPERATION, Subaru Select Monitor. >
scientia non olet · About Mike's Workshop Manuals