Read Current Data
WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Brake Control} and press the [YES] key.
- Press the [YES] key after {VDC AWD AT} is displayed.
- On the «Brake Control Diagnosis» display screen, select the {Current Data Display/Save}, and then press the [YES] key.
- On the «Display Menu» screen, select the data display method and press the [YES] key.
- Using a scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.
SUPPORT DATA CHARTDisplay Contents to be monitored Unit of measure FR Wheel Speed Wheel speed detected by front ABS wheel speed sensor RH is displayed. km/h or MPH FL Wheel Speed Wheel speed detected by front ABS wheel speed sensor LH is displayed. km/h or MPH RR Wheel Speed Wheel speed detected by rear ABS wheel speed sensor RH is displayed. km/h or MPH RL Wheel Speed Wheel speed detected by rear ABS wheel speed sensor LH is displayed. km/h or MPH Steering Angle Sensor Steering angle detected by steering angle sensor is displayed. deg Yaw Rate Sensor Vehicle angular speed detected by yaw rate sensor is displayed. deg/s Pressure Sensor Brake fluid pressure detected by pressure sensor is displayed. bar Lateral G Sensor Vehicle lateral acceleration detected by lateral G sensor is displayed. m/s (m/s/2) IG power supply voltage Voltage supplied to VDCCM&H/U is displayed. V EMA signal Engine control command signal is displayed. 1 or 0 TCS Operation Light TCS operation condition is displayed. ON or OFF VDC Operation Light VDC operation condition is displayed. ON or OFF VDC OFF Light ON/OFF condition of VDC OFF indicator light is displayed. ON or OFF EBD Warning Light ON operation of the EBD warning light is displayed. ON or OFF ABS Warning Light ON operation of the ABS warning light is displayed. ON or OFF VDC Warning Light ON operation of the VDC warning light is displayed. ON or OFF VDC OK B Signal Malfunction of VDC sensor (except for vehicle speed sensor) is displayed. 1 or 0 Valve Relay Signal Valve relay operation signal is displayed. ON or OFF Motor Relay Signal Motor relay operation signal is displayed. ON or OFF Motor Relay Monitor Motor relay monitor signal is displayed. ON or OFF PATA Signal Operation condition of VDC OFF switch is displayed. ON or OFF BLS Signal Brake ON/OFF is displayed. ON or OFF Gear position Present gear position is displayed. - Engine Speed Present engine speed is displayed. RPM Acceleration opening angle signal Acceleration opening is displayed. % NOTE: For details concerning operation procedures, refer to the "Subaru Select Monitor Operation Manual".